Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 27 Next »

  • The Air Regulator controls the primary air pressure for the CMC and helps control the pressure for the Clamps, Head Plunge, Blade Plunge and Blade Depth.

  • It usually sits at 60-70 psi.

    • It is set at the factory and does not need adjusting.

  • The Air Regulator is self releasing when the Air Compressor is turned off.

  • Check the Air Regulator at least once a week for any buildup of moisture or oil.

Connections:

  • The Air Regulator is connected between the Board and the Air Compressor.

Troubleshooting:

  • Q: If the matboard is being pushed aside when you try to cut because the Air Clamps are not inflating:

    • A: Make sure that the Air Compressor is on.

  • Q: When you first turn on your Air Compressor, you may hear air escaping from the Air Regulator.

    • A: It will do this until it builds up enough pressure and will seal itself off.

AirRegulatorV4AttachToBracket800.png
  • No labels