">

Click here to check out our new How To section">Click here to check out our new How To section

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 30 Next »

  • If the Inside Cut of the V-Groove cuts with a Swoop, Increase the Inside Rotation.

  • If the Inside Cut of the V-Groove cuts with a Flare, Decrease the Inside Rotation.

  • A Swoop is where the corners Curve Inward toward the opening on the inside/outside cut of the V-Groove.

VGrooveExteriorSwoopArrows70800.pngVGrooveInteriorSwoopArrows70800.png


  • A Flare is where the corners Curve Away from the opening on the inside/outside cut of the V-Groove.

VGrooveExteriorFlareArrows70800.pngVGrooveInteriorFlareArrows70800.png

 How to Adjust the Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels