You are viewing an old version of this page. View the current version.
Compare with Current View Page History
Version 1 Next »
If the Backup is Too Long, Decrease the Backup.
For Additional Information: See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting.
The Backup controls where the Crease cartridge Plunges into the Matboard.
If the Backup is Too Short, Increase the Backup.
The Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.
See: Backup on Creases in Configurations
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
