How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

How to Make a Classic Stairstep Design

  • This will walk you through using a #201: 4 Staircase and a #402: Classic design and merging them together to create a single design.

ClassicStairDone800.png

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring over a template #201: 4 Staircase and a #402: Classic onto the Editor.

  • NOTE: Selecting different Templates and adjusting their Parameters will give you an unlimited range of creative options.

ClassicStairStart800.png

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #402: Classic and #201: 4 Staircase openings.

    • Remember that we are going to merge the two templates together so keep that in mind when sizing the design.

ClassicStairSize800.png

  • Click on the Bottom #201: 4 Staircase opening.

  • In the Rotation field, enter 90 for the degree of Rotation.

  • The #201: 4 Staircase will be rotated 90°.

  • Note: If you place the #402: Classic opening on the bottom and rotate that opening, you will get a different result when they are merged.

ClassicStairRotate800.png

  • Move the #402: Classic and the #201: 4 Staircase openings into the center of the mat.

ClassicStairCenter800.png

  • Select both openings and click the Group Selection button.

ClassicStairGroup800.png

  • The two openings should merge where they overlapped.

  • If you need to make an adjustment to the design, click the Group Selection button to unmerge them, then click on the background to unselect them.

  • Re-edit as desired and then regroup them again.

ClassicStairGrouped800.png

  • The edited Classic Stairstep design is now completed.

NOTES:

  • You can repeat this process to merge any two templates together in any fashion as long as they share the same Bevel Type.

  • Try different degrees of Rotation.

  • Experiment with using different sized Templates.

  • Try using different Templates.

  • You can also adjust the Template’s Parameters which will give you endless creative options for your creative abilities.

  • Remember: Have fun!

ClassicStairDone800.png
  • No labels