How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

How to Make a Double Corner Insets Design

  • This will walk you through using two #202: 4 Octagon In designs and merging them together to create a single design.

  • Note: This will also have the same results with:

    • #203: 4 Classic

    • #204: 4 Triangle

    • #205: 4 Square

  • Try some of the corner feature mats such as #206: Octangle for a similar result.

DblCornerDone800.png

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring two template #202: 4 Octagon In onto the Editor.

  • NOTE: Selecting different Templates and adjusting their Parameters will give you an unlimited range of creative options.

DblCornerStart800.png

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the two #202: 4 Octagon In openings.

    • Remember that we are going to merge the two templates together so keep that in mind when sizing the design.

DblCornerSize800.png

  • Click on the Bottom #202: 4 Octagon In opening.

  • In the Rotation field, enter 90 for the degree of Rotation.

  • The #202: 4 Octagon In will be rotated 90°.

DblCornerRotate800.png

  • Move each of the #202: 4 Octagon In openings into the center of the mat.

DblCornerCenter800.png

  • Select both openings and click the Group Selection button.

DblCornerGroup800.png

  • The two openings should merge where they overlapped.

  • If you need to make an adjustment to the design, click the Group Selection button to unmerge them, then click on the background to unselect them.

  • Re-edit as desired and then regroup them again.

DblCornerMerged800.png

  • The edited Double Corner Inset design is now completed.

  • NOTE: You can repeat this process to merge any two templates together in any configuration as long as they share the same Bevel Type.

DblCornerDone800.png
  • No labels