">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

Version 1 Next »

How to make a #703/#704 Inset Rectangle With Additional Openings

  • This will walk you through creating a #703: Inset Rect R and #704: Inset Rect L and merging them together to create a single design.

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring the template #704: Inset Rect L onto the Editor.

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #704: Inset Rect L opening.

    • Remember that we are going to merge the two halves together so keep that in mind when sizing the design.

Inset2Start800.png
  • Click on the Parameters Tab.

  • Adjust the Parameters as desired for the left side of this design.

Inset2StartParams800.png
  • On the Openings Tab, bring the template #703: Inset Rect R onto the Editor.

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #704: Inset Rect L opening.

    • Remember that we are going to merge the two halves together so keep that in mind when sizing the design.

Inset2Start2ndPiece800.png
  • Click on the Parameters Tab.

  • Adjust the Parameters as desired for the left side of this design.

Inset2Start2ndPieceParams800.png
  • Position the openings as desired, overlapping the center edges.

  • Make sure that both layers of the designs overlap.

    • If needed, go back and adjust the size of the openings and try overlapping again.

Inset2Overlap800.png

  • No labels