Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 49 Next »

Installing the Mat Alignment Plate for the CMC Z1 and Z(9000z).

Mat Alignment Plate Stabilizer

  • The Mat Stabilizer is used to support smaller pieces of matboards that don’t extend far enough to be gripped by at least two finger clamps along the bottom of the board.

  • It can be moved where desired to help support the right side of the mat board being cut.

  • The Head Alignment Plate is used to assist in the alignment of smaller pieces of matboard.

Remove Horizontal Enclosure

Remove Head Alignment Block

Install New Head Alignment Block

Reattach Horizontal Enclosure

Using the Mat Stabilizer

  • No labels