You are viewing an old version of this page. View the current version.
Compare with Current View Page History
« Previous Version 64 Next »
If the Backup is Too Long, Decrease the Backup.
If the Backup is Too Short, Increase the Backup.
For Additional Information: See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting.
Select desired Cartridge Tab.
Select the desired Bevel Type from Current Bevel Type.
Edit the desired Configuration field.
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
The Backup controls where the Crease cartridge Plunges into the Matboard.
The Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.
See: Backup on Creases in Configurations
