How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 46 Next »

Corner Pause on Non-Blade Cartridges

  • The Non-Blade Tool Tears the Corners, Increase the Corner Pause. 

  • The Non-Blade Tool is pausing too long in the Corners, Decrease the Corner Pause. 

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 How to Adjust the Corner Pause

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Tool is Tearing the Mat Surface

  • The Non-Blade Tool Tears the Corners, Increase the Corner Pause. 

  • The Non-Blade Tool is pausing too long in the Corners, Decrease the Corner Pause. 

 Corner Pause General Definition

The Corner Pause setting in Configurations is the amount of time, in milliseconds, to pause the application of the Non-Blade Tools between segments.

The Non-Blade Tool Tears the Corners, Increase the Corner Pause. 

The Non-Blade Tool is pausing too long in the Corners, Decrease the Corner Pause. 

 How to Adjust the Corner Pause

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels