">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 101 Next »

Exterior Backup on Openings

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 When Cutting from the Front

Cutting from the Front will cut with the face of the mat toward the operator, and can be selected on the Cutting Preview.

  • On the Configurations screen the Current Bevel Type dropdown control will display the bevel types in this manner:

    • Cut from the Back bevel type names will be displayed with no further label; i.e., Normal Bevel.

    • Cut from the Front bevel type names will be displayed with a Front label; i.e., Normal Bevel-Front of Mat.

    • V-Grooves have their own selection on the list.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat.

So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening.   

 How to Adjust the Exterior Backup

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Opening Exterior Backup Too Long

 Exterior Backup on Opening Definition

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cuts of Openings. 

The Exterior Cut is where the Blade Plunges or Retracts from the Matboard (not the Fallout).    

If the Exterior Backup is cut Too Long, Decrease the Exterior Backup.

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

 How to Adjust the Exterior Backup

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Opening Exterior Backup Too Short

 Exterior Backup on Opening Definition

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cuts of Openings. 

The Exterior Cut is where the Blade Plunges or Retracts from the Matboard (not the Fallout).    

If the Exterior Backup is leaving a Hook in the corner, Increase the Exterior Backup.

If the Exterior Backup is cut Too Short, Increase the Exterior Backup.

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

 How to Adjust the Exterior Backup

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels