">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 13 Next »

Change the Blade on the 90 Degree Cartridge

  • The 90° plastic green blade cartridge is designed to cut 90° bevels on standard 4-ply matboard.

  • The 90° plastic green blade cartridge is labeled 90 on the end.

  • The 90° plastic green blade cartridge does not support blade depths above 16.

  • Push blade cartridge release down to eject the current blade cartridge.

  • Rotate the blade cover open and remove the blade from blade cartridge.

  • Mind the sharp edge.

  • The blade cartridge displays a diagram of the blade orientation (shown in contrast). 

  • Place new blade into cartridge with the longest straight side to the right and the bevel face down, lining up the holes of the blade over the pins in the cartridge.

  • The blade should fit snugly into the recess space provided for it.

  • NOTE: If there is side-to-side movement of the blade in the blade cartridge, or if chunks have been cut out of the cartridge, then it is time to replace the blade cartridge.

  • Turn cartridge over and reinsert into the head with the blade facing the CMC board and the notch on the back of the cartridge facing the head, until it clicks into place. It can only be inserted one way.

  • No labels