Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 39 Next »

Cutting a Typical Matboard with the CMC Z1, Z(9000z), 9000 and 8000+

Note: Decreasing the air pressure will decrease the blade depth.

  • FrameShop will prompt for a head pressure change only if the current mat is a different setting than the previously cut mat.

  • All designs come to the Cut Preview with Dense unchecked on the Cut Speeds screen.

  • Returning to the editor then going to the Cut Preview resets the layers to typical matboard with Dense unchecked.

  • Click Cut to cut the mat and Align the Head if requested.

  • The Head plunges at the home position and applies the current pressure and displays a prompt to adjust the head pressure to the low setting.

  • Pull out the air regulator pressure knob by pulling it to the left.

  • Turn the air regulator pressure knob counter-clockwise until the marker on the gauge is at the low setting.

  • Make sure the gauge does not go below 30 psi.

  • Push the air regulator pressure knob back in by pushing it to the right.

  • Click OK to cut the mat with this setting.

  • No labels