">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 15 Next »

Cut the Outside as a Shared Edge

  • Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts on the CMC Z1 and Z (9000z).   

 Shared Edge Definition

The Shared Edge function will cut the Shared Edges of the Tiled Outside Cuts on the CMC Z1 and Z (9000z) as one stroke between the designs, instead of cutting the outside of each mat individually.

  • When Tiling, make sure that the Spacing under the Setup Tab is set to Zero (0) so that each design shares the Outside lines with the next design, so it will only cut the single line between them. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

 Remnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Advanced Outside Options

  • The Shared Outside edges of the Tiled design will cut in one stroke. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

 Remnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Defaults: Set the Default for Cutting the Outside 

 Default Setting for Cutting the Outside

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Defaults: Set the Default for 90 Degree Outside Cut

 Default Setting for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Defaults: Set the Default for the Advanced Options

 Default Setting for the Default Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Defaults: Set the Default for the Cut Mode

 Default Setting for Default Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section.

  • No labels