">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 13 Next »

Cut the Full Outside Edge

  • Select Full from the Outside Cut Options dropdown control to cut the complete outside edge of the design on the CMC Z1 and Z (9000z).

  • When Tiling mats, it will cut out the complete outside edge of each design.

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

 Remnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Advanced Outside Options

  • The full Outside edge of the design or Tiled designs will be cut. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

 Remnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Defaults: Set the Default for Cutting the Outside 

 Default Setting for Cutting the Outside

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Defaults: Set the Default for 90 Degree Outside Cut

 Default Setting for the 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Defaults: Set the Default for the Advanced Options

 Default Setting for the Default Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Defaults: Set the Default for the Cut Mode

 Default Setting for the Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section.

  • No labels