Skip to end of metadata
Go to start of metadata
You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 21
Next »
Cartridges Involved |
|---|
This Configuration element involves the following Cartridges. |  |
Exterior Overcut Definition |
|---|
Exterior Overcut Definition The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. | |
Select the Bevel Type for the Exterior Overcut to be Edited: |
|---|
Problem: Exterior Overcut Definition The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut. If the exterior overcut is too short, increase the Exterior Overcut. See Exterior Overcut on Openings for additional information.
| |
Problem: Exterior Overcut Definition The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut. If the exterior overcut is too short, increase the Exterior Overcut. See Exterior Overcut on Drops for additional information.
| |
Problem: Exterior Overcut Definition The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut. If the exterior overcut is too short, increase the Exterior Overcut. See Exterior Overcut on the Outside for additional information.
| |
Problem: V-Groove Exterior Overcut Definition The V-Groove Exterior Overcut controls where the blade retracts from the matboard on exterior cuts on the outside cut of the V-Groove. Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut. If the exterior overcut is too short, increase the Exterior Overcut. See Exterior Overcut on V-Grooves for additional information.
| |
Problem:
The Exterior Overcut on Creases is applied too long/too short.
Exterior Overcut Definition The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts. Resolution:
If the exterior overcut is too long, decrease the Exterior Overcut. If the exterior overcut is too short, increase the Exterior Overcut. See Exterior Overcut on Creases for additional information.
| |