">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 15 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Exterior Overcut Definition

  • The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts.

  • The Exterior Cuts cut into the matboard, not the fallout.

  • The Exterior Overcut field is marked with a Red Arrow.

Select the Bevel Type for the Exterior Overcut to be Edited:

Exterior Overcut on Openings

Problem:

  • The Exterior Overcut on Openings is cut too long/too short.

Resolution:

Edit the Exterior Overcut on Openings.

  • Normal Bevel

  • Reverse Bevel

  • Normal Bevel-Front of Mat

  • Reverse Bevel-Front of Mat

Exterior Overcut on Drops 

Problem:

  • The Exterior Overcut on Drops is cut too long/too short.

Resolution:

Adjust the Exterior Overcut on Drops.

  • Normal Drop

  • Reverse Drop

  • Normal Drop-Front of Mat

  • Reverse Drop-Front of Mat

Exterior Overcut on the Outside

Problem:

  • The Exterior Overcut for Outsides is cut too long/too short.

Resolution:

Adjust the Exterior Overcut on the Outside.

  • Outside

  • Outside-Front of Mat

Exterior Overcut on V-Grooves 

Problem:

  • The Exterior Overcut for V-Grooves is cut too long/too short.

Resolution:

Adjust the Exterior Overcut on V-Grooves.

  • V-Grooves

Exterior Overcut on Creases

Problem:

  • The Exterior Overcut on Creases is applied too long/too short.

Resolution:

Adjust the Exterior Overcut on Creases.

  • Crease

  • No labels