">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation Definition on V-Grooves

The Rotation field controls how much the foot block will rotate before cutting. Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.

  • The first cut is the interior V-Groove line.

  • The second cut is the exterior V-Groove line.

Adjust the Outside Rotation if you are getting Swoops or Flares in the outside corners on a non-oval opening.

V-Groove Outside has a Swoop

  • The beginning of the outside cut of the V-Groove Swoops toward the non-oval V-Groove opening.

  • Decrease the Outside Rotation.

  • When making adjustments, click the minus button (-) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The object will now cut correctly.

V-Groove Outside has a Flare

  • The beginning of the outside cut of the V-Groove Flares away from the non-oval V-Groove opening.  

  • Increase the Outside Rotation value. 

  • When making adjustments, click the plus button (+) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The object will now cut correctly.

See Also: V-Groove Inside Rotation

  • Select this topic to see information on the Inside Rotation (V-Groove) to adjust the rotation for the inside cut of the non-oval V-Groove.

  • No labels