Cutting Defaults
Cutting Defaults | |
---|---|
| Default Settings for the Cutting Preview |
Cut Screen Settings | |
---|---|
| Default Settings for the Cut Screen Settings |
Remember Previous
| |
Start With Settings | |
Auto OffsetThe Auto Offset moves the design up and over on the Cut Preview to avoid the Clamp area. This is to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview. See: Auto Offset Setting | |
Continuous LayerThe Continuous Layer will keep cutting the Current Layer without rolling over to the next layer. It will stay on the Current Layer until the user manually selects a different layer or turns off Continuous Layer. | |
Cut from FrontCutting from the Front will cut with the face of the mat toward the operator, and can be selected on the Cutting Preview.
If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat. So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening. Cutting from the Back will cut with the back of the mat toward the operator, and can be selected on the Cutting Preview.
If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat. | |
90 Degree OutsideThe Outside Bevel is created by cutting into the fallout surface with the blade angled at 45°/52°, thereby slanting the bevel under the fallout surface. The matboard core is not visible from the front. The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut. Select Outside or Outside-Front of Mat from the Current Bevel Type dropdown control to edit this configuration. See: 45 Degree Outside Configurations See: 45 Degree Plus Outside Configurations See: 45 Degree Front Outside Configurations | |
Tangent Threshold | |
Show Previous Cuts |
Default Blade Depths | |
---|---|
Default DepthV-Groove Depth |
CMC Board Size | |
---|---|
Tiling Defaults | |
---|---|
Sheet SizeSpacing |
Advanced Outside Settings | |
---|---|
|
Cut Mode | |
---|---|
Cut Mode: Shared Edge | |
Cut Mode: Full | |
Cut Mode: As Designed |
Remnant Trimming | |
---|---|
Remnant Trimming: Off | |
Remnant Trimming: Auto | |
Remnant Trimming: Horizontal | |
Remnant Trimming: Vertical |
Dense Material | |
---|---|
Cut From Front Blade Cartridge Selection | |
---|---|