This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

Box Thickness

Enter the thickness for the material the box is being cut from in the Thickness field.

This field also controls which Creasing Tool is used to create the creases when cutting the box: it uses either the Creasing Tool or the Deboss Tool.

The software will also calculate where the fold lines should be based on the thickness and the box template selected. 

Thickness: Deboss

Select this topic to see information on thicknesses of 3/32” and below which will use the Deboss cartridge to create fold lines when cutting.

Thickness: Crease

Select this topic to see information on thicknesses of 1/8” and above which will use the Crease cartridge to create fold lines when cutting.

  • No labels