Exterior Overcut on the Outside | |
|---|---|
The Exterior Overcut is where the cut continues into the corner before retracting the blade from the matboard on the exterior cuts, such as when cutting a rectangle. Exterior Cuts cut into the matboard, not the fallout of the opening. |  |
Current Outside Bevel Type | |
|---|---|
Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
|  |
Red Arrow on the Configuration Map | |
|---|---|
The Exterior Overcut is displayed on the Configuration Map as a red arrow. |  |
Check against the Configuration Map of the Bevel Type you are cutting to determine specifically which cuts are the Exterior Overcuts. |  |
Exterior Cuts, such as rectangles, cut into the matboard, not the fallout of the opening. |  |
Outside Exterior Overcut Too Short | |
|---|---|
If the Exterior Overcut retracts the blade too soon, it makes the exterior overcut too short. |  |
Increase the Exterior Overcut. |  |
Outside Exterior Overcut Too Long | |
|---|---|
If the Exterior Overcut retracts the blade too late, it makes the exterior overcut too long. |  |
Decrease the Exterior Overcut. | |
Outside Interior Overcuts | |
|---|---|
For Overcuts where the blade comes out of the fallout instead of the matboard, see Interior Overcut. |  |