This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Next »

Remnant Trimming

Select the desired remnant trimming direction on the CMC 9000z and Z1 from the Remnant Trimming dropdown control. This will trim off the remaining section of the matboard to make it easier to store the remaining pieces for future use.   

Set Advanced Options: Remnant Trimming 

Click the Set Advanced Options button to access the Advanced Outside Options. 

Make the desired selection for the Remnant Trimming as described below.

Click OK.

The CMC will cut with these settings.

Remnant Trimming: Off

Set Remnant Trimming to Off to not cut off the remnant from the sheet of matboard.

Click Set Advanced Options to access the Advanced Outside Cut Options.

Set Remnant Trimming to Off.

The design will cut but not trim off the remnant that remains from the matboard.

Remnant Trimming: Auto

Set Remnant Trimming to Auto to let the software determine the best direction to cut off the remnant.

Click Set Advanced Options to access the Advanced Outside Cut Options.

Set Remnant Trimming to Auto to let the software determine the best direction to cut off the remnant.

The software will automatically determine the best direction to cut off the remnant matboard by selecting either vertically or horizontally depending upon the design.

Remnant Trimming: Horizontal

Set Remnant Trimming to Horizontal to default to cut the remnant off horizontally.

Click Set Advanced Options to access the Advanced Outside Cut Options.

Set Remnant Trimming to Horizontal.

The design will cut and trim off the remnant matboard horizontally.

Remnant Trimming: Vertical

Set Remnant Trimming to Vertical to set the default to cut the remnant matboard off vertically.

Click Set Advanced Options to access the Advanced Outside Cut Options.

Set Remnant Trimming to Vertical.

The design will cut and trim off the remnant matboard vertically.

Set the Default for Cutting the Outside 

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for 90 Degree Outside Cut

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Set the Default for the Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for Remnant Trimming

The default setting for the Remnant Trimming can be set in the Admin > Cutting section.

  • No labels