This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 13 Next »

Align the Head

Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat. Aligning the Head will only get the machine ready to cut, but not actually cut.

Align the Head Button vs. the Cut Button

Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head. After the Head is Aligned, it will then Cut the mat.

Align the Head on the CMC 8000

Select this topic to see information on Aligning the Head on the CMC 8000.

Align the Head on the CMC 9000

Select this topic to see information on Aligning the Head on the CMC 9000.

Align the Head on the CMC 9000z

Select this topic to see information on Aligning the Head on the CMC 9000z.

Align the Head on the CMC Z1

Select this topic to see information on Aligning the Head on the CMC Z1.

  • No labels