Setting the 45 Degree Front Cartridge Default Setting

Selecting the Default Setting to Use the 45° Front Blade Cartridge

The 45° Front Blade Cartridge cuts the bevel angle on the matboard at 45° from the Front of the mat.
The 45° Front Blade Cartridge is not selected within the Editor; it is set by setting Cut From Front on the Cut Preview.

45 Degree Front Cartridge

The 45° Front Cartridge cuts the Bevel Angle on the matboard from the Front at 45°.
This Bevel Angle is displayed on the Front or the Back of the mat depending upon the selected Bevel Type.
The 45° Front Blade Cartridge is not selected within the Editor; it is set by setting Cut From Front on the Cut Preview.

Select Change to 45° Front Blade to default to using the 45° Front Blade Cartridge when cutting a design from the front of the mat.
Click Save.
It will now use the 45° Front Blade Cartridge when you are cutting from the front.

Default Settings
Cut from Front: Cutting Default Setting Cut From Front Blade Cartridge Selection: Cutting Default Setting