You are viewing an old version of this content. View the current version.
Compare with Current View Version History
« Previous Version 10 Next »
Set the Tiling defaults for cutting the same design across the matboard from the Setup Tab on the Cut Preview.
Set the default Spacing between designs when Tiling.
Example: Enter 0 inches when cutting with a Shared Edge.
The Tiling function duplicates the current opening on the selected matboard size, to cut any number of copies efficiently in a single sequence.
Full Definition: Tiling Definition
90 Degree Outside Cut: Cut Preview Set Advanced Options
Adjusting the 90 Degree Cartridge Cut Speed for Extra Dense Material
Air Pressure for Cutting with the 90 Degree Cartridge
Cut Mode Set Advanced
Cut Outside Options Menu: Cut Preview
Cut the Outside: Cut Preview Toggle
Cut the Outside Display
Cut Speeds Button: Cut Preview Options
Cut Speed Percentage: Cut Speeds Screen
Cutting an Extra Dense Layer with the 90° Cartridge
Enable Outside Cut: Cut Preview Set Advanced Options
Extra Dense Material Cut Speeds: Cut Speeds Screen
Matboard: Cut the Outside Editor Properties Tab
Not Cutting the Outside Display
Outside Cut Shared Edge: Cut Preview Outside Cut Options
Outside Cut Off: Cut Mode Advanced Options
Outside Cut Options: Cut Preview
Selecting the 90 Degree Cartridge in the Editor
Selecting the 90 Degree Cartridge Outside Cut: CMC 8500eSBT, 9000 and 8000+
Selecting the 90 Degree Cartridge Outside Cut: CMC Z Series
Shared Edge: Cut Mode Advanced Options
Tiling the Design: Setup Tab
Tiling: How to Tile a Design
Tiling: Number of Mats: Setup Tab
Tiling: Sheet Size: Setup Tab
Tiling: Spacing: Setup Tab
Tiling: Total Sheets: Setup Tab
Variable Pressure Optimization (VPO) Feature
90 Degree Outside: Cutting Default Setting
Advanced Outside Settings: Cutting Default Setting
Cut Mode: Cutting Default Setting
Cut the Outside: Editor Default Setting
Shared Edge Cut Mode: Cutting Default Setting
Sheet Size: Cutting Default Setting
