">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 41 Next »

Changing the 45 Degree Blade: CMC Z1, Z(9000z), 9000, 8500eSBT, 8500e, 8500, 8000, 8000RC and 8000+

  • The black 45° Blade Cartridge is labeled “45” on the end.

End45Cartridge70800.png

  • Your hardware may look different than the model pictured, but the process is still the same.

  • Push the Blade Cartridge release lever down to eject the Blade Cartridge.

  • Remove the Blade from Blade Cartridge, being mindful of the sharp edge.

  • The Blade Cartridge displays a diagram of the Blade orientation (shown in contrast). 

  • Place new Blade into Cartridge with the longest side to the right and the bevel face down, lining up the bottom hole of the Blade over the pin in the Cartridge.

  • The Blade should fit snugly into the recess space provided for it.

  • NOTE: If there is any side-to-side movement of the Blade in the Blade Cartridge, it is time to replace the Blade Cartridge.

  • Insert the Blade Cartridge into the Head with the Blade facing toward the Board and the notch on the back of the Cartridge facing the Head.

  • It should click into place.

    • It can only be inserted one way.

  • No labels