">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

V-Groove Exterior Overcut is Too Long

  • If the Exterior Overcut on the Outside Cut of the V-Groove is cut Too Long, Decrease the Exterior Overcut.

🛠️ Click the Plus or Minus button several times on the desired field, do a test cut and continue adjusting until satisfied.

  • The Exterior Overcut for V-Grooves controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cuts of the Outside Cut of the V-Groove.

    • If Exterior Overcut on the V-Groove Outside cuts Too Long, Decrease the Exterior Overcut.

    • If Exterior Overcut on the V-Groove Outside cuts Too Short, Increase the Exterior Overcut.

Full Definition: Exterior Overcut for V-Grooves Definition

  • No labels