">

Click here to check out our new How To section">Click here to check out our new How To section

Skip to end of banner Go to start of banner

V-Groove Inside Cut has a Bump

Skip to end of metadata

Created by dani.simmonds, last modified on Oct 14, 2024

Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

V-Groove Inside Cut has a Bump

If the Inside cut of the Oval V-Groove has a Bump, Increase the Inside Oval Rotation.

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.
- If Oval has a Bump, Increase the Oval Rotation.

Full Definition: Bump in an Oval Definition

For Additional Information:
Circle/Oval Rotation Utility: Configurations Screen
Troubleshooting Utility for the Configurations

How to Adjust the Oval Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

No labels