">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 95 Next »

Oval Rotation on Oval V-Grooves

Contents:

Because this is an Oval V-Groove, you will be using either the Outside Oval Rotation or the /wiki/spaces/FrameShop8x/pages/1942502544, based on which V-Groove oval line you are editing.

  • If the Outside cut of the Oval V-Groove has a Feather, Increase the Outside Oval Rotation.

  • If the Outside cut of the Oval V-Groove cuts with a Bump, Decrease the Outside Oval Rotation.

  • If the Inside cut of the Oval V-Groove has a Feather, Decrease the Inside Oval Rotation.

  • If the Inside cut of the Oval V-Groove cuts with a Bump, Increase the Inside Oval Rotation.

  • A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended on the Oval.

OvalBevelOpeningFeather70800.png

Full Definition: Feather in an Oval V-Groove Definition

  • A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

OvalBevelOpeningBump70800.png

Full Definition: Bump in an Oval Definition

 How to Adjust the Oval Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

  • No labels