">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 74 Next »

Oval Rotation on Openings

 How to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

 Cut from Front Full Definition

Cutting from the Front will cut with the face of the mat toward the operator, and can be selected on the Cutting Preview.

  • On the Configurations screen the Current Bevel Type dropdown control will display the bevel types in this manner:

    • Cut from the Back bevel type names will be displayed with no further label; i.e., Normal Bevel.

    • Cut from the Front bevel type names will be displayed with a Front label; i.e., Normal Bevel-Front of Mat.

    • V-Grooves have their own selection on the list.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat.

So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening.   

 How to Adjust the Oval Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Oval Opening has a Feather

 Feather in Oval Opening Definition

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended on the Oval.

If the Oval Opening has a Feather, Decrease the Oval Rotation.

The Oval Rotation controls for Bumps or Feathers on an Oval.

 How to Adjust the Oval Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Oval Opening has a Bump

 Bumps in Oval Opening Definition

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

If the Oval Opening has a Bump, Increase the Oval Rotation.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

 How to Adjust the Oval Rotation

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Troubleshooting Utility for Ovals

Circle/Oval Rotation Utility

  • No labels