">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Folded Flag Using the #310: Dutch Dome Template

  • These instructions will walk you through creating a folded flag opening using the #310: Dutch Dome Template.

310FoldedFlagDone800.png

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring the template #310: Dutch Dome template onto the Editor.

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #310: Dutch Dome opening.

310FoldedFlagSize800.png

  • Click on Parameters.

  • Change the Chamfer to the desired angle.

310FoldedFlagChamfer800.png

  • Click on the Reveals tab.

  • Select the top layer and change it to use the 90° cartridge.

    • This layer represents our outside cut for this design.

310FoldedFlag90Outside800.png

  • Under Reveals tab, enter what you would like for the size of the borders.

  • Both of these layers will actually be cut onto the same layer.

    • The smaller triangle will be the opening, and the larger triangle will be the outside.

310FoldedFlagReveal800.png

  • Save the design.

  • When you cut it, do not select to Cut the Outside.

  • Instead, cut the Opening then without moving the mat, cut the Outside Layer on top of it.

310FoldedFlagCutPreview800.png

  • The Folded Flag using the #310: Dutch Dome template is finished.

310FoldedFlagDone800.png
  • No labels