How Tosectionat:[HowTo...]">Check out our new How To section at: How To...

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

How to make a #703/#704 Inset Rectangle With Additional Openings

  • This will walk you through creating a #703: Inset Rect R and #704: Inset Rect L and merging them together to create a single design.

  • Click New Mat Design on the FrameShop Main Page.

  • Click Cancel on the New Openings Screen.

  • On the Openings Tab, bring the template #704: Inset Rect L onto the Editor.

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #704: Inset Rect L opening.

    • Remember that we are going to merge the two halves together so keep that in mind when sizing the design.

Inset2Start800.png

  • Click on the Parameters Tab.

  • Adjust the Parameters as desired for the left side of this design.

Inset2StartParams800.png

  • On the Openings Tab, bring the template #703: Inset Rect R onto the Editor.

  • Click on the Properties Tab to edit it.

  • Enter the desired size for the #704: Inset Rect L opening.

    • Remember that we are going to merge the two halves together so keep that in mind when sizing the design.

Inset2Start2ndPiece800.png

  • Click on the Parameters Tab.

  • Adjust the Parameters as desired for the left side of this design.

Inset2Start2ndPieceParams800.png

  • Position the openings as desired, overlapping the center edges.

  • Make sure that both layers of the designs overlap.

    • If needed, go back and adjust the size of the openings and try overlapping again.

Inset2Overlap800.png

  • No labels