Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Push to Cut Button Definition

  • The Push to Cut Button allows the user to cut the current design on the Cut Preview Screen without returning to the computer.

  • If required, you will be asked to Align the Head

  • During cutting, you can also use the Push to Cut Button to pause the cut.

Connections:

  • The Push to Cut Button is usually located on the Control Panel on the left side of the Board for CMCs that include this feature.

Troubleshooting:

  • Pushed the Push to Cut Button and it doesn’t cut.

    • Check to make sure the Emergency Stop Button isn’t pressed in.

    • Are the connection cables for the ECU on tight?

    • Turn off the ECU/Driver Pack close the software. Turn on the ECU/Driver Pack restart the software.

    • If clicking Cut on the Cut Preview screen works but pushing the Push to Cut Button does not, contact Technical Support.

  • No labels