You are viewing an old version of this page. View the current version.
Compare with Current View Page History
« Previous Version 56 Next »
If the Crease has a Swoop, Increase the Rotation.
If the Crease has a Flare, Decrease the Rotation.
Select desired Cartridge Tab.
Select the desired Bevel Type from Current Bevel Type.
Edit the desired Configuration field.
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.
Click OK and do another test cut.
Continue making adjustments until the desired outcome is achieved.
A Swoop in a Crease is where the corners Curve Inward toward the crease.
The Rotation controls for Swoops and Flares in Openings.
A Flare in a Crease is where the corners Curve Away from the crease.
Use the Troubleshooting Configurations to fine-tune for Swoops/Flares in a Crease.
