">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 50 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Oval Rotation Definition

 Oval Rotation Definition

The Oval Rotation controls for Feathers or Bumps on an Oval Opening.

 Feather Definition

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

 Bump Definition

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Bump, Increase the Oval Rotation.

Adjusting the Oval Rotation

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Current Bevel Type

Oval Opening has a Feather

Problem:

  • The Oval Opening cuts with a Feather.

Resolution:

  • If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

 Feather Definition

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

Oval Opening has a Bump

Problem:

  • The Oval Opening cuts with a Bump.

Resolution:

  • If the Oval Opening cuts with a Bump, Increase the Oval Rotation.

 Bump Definition

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Bump, Increase the Oval Rotation.

See Also: Troubleshooting Utility for Ovals

Problem:

  • The Oval Opening cuts with a Feather/Bump.

Resolution:

 Feather Definition

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

 Bump Definition

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Bump, Increase the Oval Rotation.

See Also: Circle/Oval Rotation Utility

Problem:

  • The Oval cuts with a Feather/Bump.

Resolution:

 Feather Definition

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

 Bump Definition

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Bump, Increase the Oval Rotation.

  • No labels