">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 39 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Oval Rotation Definition

 Oval Rotation Definition

The Oval Rotation controls for Feathers or Bumps on an Oval Opening.

 Feather Definition

A Feather in an Oval Opening is a fringe of material left in the opening that shows where the cut started and ended.

 Bump Definition

A Bump in an Oval Opening is a lump of material that shows where the cut started and ended.

Adjusting the Oval Rotation

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Current Bevel Type

Oval Opening has a Feather

Problem:

  • The Oval Openings is cut with a feather.

Resolution:

  • Decrease the Oval Rotation.

Oval Opening has a Bump

Problem:

  • The Oval Openings is cut with a bump.

Resolution:

  • Increase the Oval Rotation.

See Also: Troubleshooting Utility for Ovals

Problem:

  • The Circle/Oval Opening cuts with a Feather/Bump.

Resolution:

See Also: Circle/Oval Rotation Utility

Problem:

  • The Circle/Oval cuts with a Feather/Bump.

Resolution:

  • No labels