">
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 18 Next »

Troubleshooting the Backup/Overcut Display

  • Have a cut design design displayed on the Cut Preview. This feature is only available for the bladed cartridges.

  • Using one of the zoom buttons, zoom in to the desired section of the project where you are having issues cutting.

  • Make sure that the Green Backups and Red Overcuts lines are visible.

  • With the cursor hovering over one of the Backups or Overcuts, the status bar displays the actual physical length of the selected Backup or Overcut.

  • This value will be the sum of the corresponding user configuration setting and the factory configuration setting.

  • The cursor will turn into an arrow with a question mark.

  • Click on the desired overcut or backup line that you are having trouble with.

  • The Appropriate Cartridge Tab is Selected and the Configuration Field Associated to the line clicked on will be highlighted.

  • Now you can easily increase or decrease the value displayed, depending upon whether the item selecting is cutting too long or cutting too short.

  • Click OK and recut the design, adjusting the Configurations until you achieve the desired result.

It will open the Configurations screen with the Cartridge selected and the specific Backup or Overcut field selected.

  • No labels