">

Click here to check out our new How To section">Click here to check out our new How To section
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 15 Next »

Cartridges Involved

This Configuration element involves the following Cartridges.

  • Note: Not all cartridges are available for all CMC models.

Pen Cartridge Configurations

The Pen Cartridge draws onto the matboard with the selected pen.

Pen Tab

  • Select this topic to see information on editing the configurations for the Pen Cartridge on the Pen Tab.

  • Select the specific Pen to edit from the Cartridge dropdown control.

  • Note that each pen has its own set of configurations.

  • Below is a list of support documentation for editing the configurations of the Pen Cartridge on the Pen Tab.

Pen is Applied to the Wrong Place Horizontally 

Problem:

The Pen is Applied to the Wrong Place Horizontally.

Resolution:

Pen is Applied to the Wrong Place Vertically 

Problem:

  • The Pen is Applied to the Wrong Place Vertically.

Resolution:

  • This is viewed from the front of the mat.

Pen is the Wrong Size

Problem:

  • The Pen is the Wrong Size.

Resolution:

  • Adjust the Pen Opening Adjustment. Select this topic to see information on editing the Pen Opening Adjustment.

  • This is viewed from the front of the mat.

Pen Applied at the Wrong Depth

Problem:

  • The Pen is Applied at the Wrong Depth.

Resolution:

Adjust the Pen Depth Settings. Select this topic to see information on editing the Pen Depth Setting.

Pen Cartridge Tears the Mat

Problem:

The Pen Cartridge Tears the Mat.

Resolution:

Adjust the Pen Corner Pause. Select this topic to see information on editing the Pen Corner Pause. 

Pen Lines are too Long

Problem:

  • The Pen Lines are drawn too Long.

Resolution:

  • Adjust the Pen Overshoot. Select this topic to see information on editing the Pen Overshoot.

This is viewed from the front of the mat.

Pen Lines are too Short 

Problem:

  • The Pen lines are drawn Short.

Resolution:

  • Adjust the Pen Overshoot. Select this topic to see information on editing the Pen Overshoot.

  • This is viewed from the front of the mat.

Set Pen to Plunge Between Pen Line Segments

Problem:

  • Set the Pen to Plunge Between Pen Line Segments.

Resolution:

  • Select/Unselect the Plunge checkbox. Select this topic to see information on editing the Plunge between segments.

Calibrating Different Pens

Problem:

  • How to Calibrate Different Pens.

Resolution:

  • Use the Install Pen utility to calibrate pens. Select this topic to see information on configuring different pens with the Install Pen calibration utility.

Troubleshooting Button

  • Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.

Set Pen Defaults

Set up the Pen Defaults in the Admin Editor section of the software.

  • No labels