AirGlide Acrylic Cartridge

• Loosen the Cartridge Release knob.

• Pull out the current Cartridge from the cutting head.

• Locate the Acrylic Cartridge.

• Insert the Acrylic Cartridge keeping the protruding Acrylic Cartridge Depth Adjustment Thumbwheel on the right side.

NOTE: It is not necessary to remove the protective coating from Acrylic before using the Acrylic Cartridge.

• Tighten the Cartridge Release knob to lock it in place.

• Loosen the Cartridge Release knob.

• Loosen the 1/16” set screw on the Blade Depth Adjustment Thumbwheel.

• Turn the Blade Depth Adjustment Thumbwheel to adjust the cartridge depth.

• The Blade Depth Adjustment Thumbwheel controls the depth of the acrylic/blade/glass cutter by impeding how far the cartridge can be inserted into the head.

Note that the (Optional) Composite Cartridge has no depth adjustment. See the desired tool for optimum depth further down in this document:

• Setting Acrylic Depth

• Setting Blade Depth

• Setting Glass Depth

• Push the cartridge into the cutting head to re-measure how far the cartridge tool is located in reference to the material being cut.

• Once the desired blade depth is set, tighten but don’t over-tighten the 1/16” set screw on the blade depth thumb wheel to lock it into place.

• Press the cartridge into the head and tighten the Cartridge Release knob.

• The Acrylic Cartridge depth should extend the scoring stylus to the mid-point of the material thickness being scored.