This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 24 Next »

Crease Cartridge

The Crease Cartridge creases the material to make folding it easier when making Boxes.

Crease Tab

Select the Crease Tab on the Configurations screen to edit the Crease Configurations. 

Crease Exterior Backup is too Long

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup.

Crease Exterior Backup is too Short

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup.

Crease Exterior Overcut is too Long

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut.

Crease Exterior Overcut is too Short

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut.

Crease is the Wrong Size

This is viewed from the front of the mat. Select this topic to see information on editing the Opening Adjustment.

Crease Cuts the Wrong Depth When Using a SKU

Select this topic to see information on editing the Depth Bias.

Troubleshooting Button 

Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Set Box Defaults

Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.

  • No labels