Versions Compared

Old Version 9

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Check Software Measurements

Info

  • Check the software measurements to make sure that images taken with the camera are displayed at the correct scale, so that art, mats and frame moulding will display proportionally correct.

  • Open the FrameShop software and click on Visualize.

Image Added

  • Place a measuring tape on the design table. 

Image Removed
.

Image Removed
Image Added

  • If there is more than one device available, select the desired camera from the dropdown control on the Camera Capture Screen.

Image Removed
Image Added
Image Removed
Image Added
Info

  • A photo of the measuring tape is displayed.

Image Removed
Image Added
horizontally

  • Horizontally along the

ruler

  • Ruler; take as long of a measurement as possible as this improves the software's measurements.

Image Removed
Image Added

  • A screen opens requesting the

width measurement - enter

  • Width Measurement.

  • Enter the specific width that was measured within this box.

  • Click OK. 

Info

  • The

scale

  • Scale for the camera is now set.

Image Removed
Image Added

Measure a Piece of Art

Info

  • Measure a piece of

art

  • Art taken with the

camera

  • Camera to make sure that the

scale

  • Scale is set correctly, so that

art

  • Art and

moulding

  • Moulding will display proportionally correct.

art
art

  • Art.

  • The dimensions of the image displays on the Selected Region width and height boxes.             

  • The dimensions of the image should be correct, within approximately 1/8 inches. If the dimensions are correct and the image still appears “square,” then the camera is

calibrated

  • Calibrated at this specific

fixed zoom point

  • Fixed Zoom Point.

Image Removed
Image Added

Calibration Complete 

Info

  • The

camera

  • Camera is now

calibrated

  • Calibrated and will remain calibrated as long as the camera is not physically moved.

  • If the

camera mount

  • Camera or Camera Mount is moved, the entire procedure must be repeated.

  • When saving a project to the database or to a file, the

scale setting

  • Scale Setting is saved with the project.

  • Thus, if using different zoom points and recalling a project from storage may require the

scale

  • Scale to be set again for the next new project started.

  • For

fixed zoom

  • Fixed Zoom, the software only remembers

one scale value

  • One Scale Value and that value will be changed when loading a prior project from storage.

Default Settings