Versions Compared

Old Version 7

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

These instructions will explain how to remove the Head, replace the motor, and reinstall the Head on the Eclipse.

View file
name

...

EclipseProLegacyReplacingProHeadMotors2024-03-01

...

.pdf

Parts Needed

3mm Allen Wrench, 1/8” Allen Wrench, 5/32” Allen Wrench

Remove Head

1

  • Shut down the system.

  • Remove four 3mm Allen Screws holding the Head cover in place.

Image Removed2
Image Added

  • There are two on the top and two on the bottom.

Image Removed
Image Added
3

  • Unplug Head electrical connectors and airlines; firmly grasp connector/airline and pull apart.

Image Removed
Image Added
4

  • Unscrew Head from Hinges by removing 1/8” Allen Screws underneath Head; support the Head. Keep Hinges attached to Trolley.

  • Remove the Head and set aside.

Image Removed
Image Added

Remove Motor

1

  • Remove three 5/32” Allen screws holding motor to Head.

Image Removed
Image Added
2

  • Pull out motor.

Image Removed
Image Added

Replace Motor

1

  • Remove Blade and hold Head with Head Latch on top.

Image Removed2
Image Added

  • Insert new motor into position, lining up motor/Head screw holes.

Image Removed3
Image Added

  • Loosely finger-tighten 5/32” Allen screws, and push motor upwards, then let motor drop about 1/16”.

Image Removed
Image Added
45

  • Fully tighten Allen Screws into place.

Image Removed
Image Added

  • Rotate and plunge/unplunge footblock and check for any binding. If you feel any binding in the gears, loosen the Allen Screws holding the motor in place and pull it down slightly, then retighten. Repeat as necessary.

Image Removed
Image Added

Attach Head

  • Attach Head to Hinges using 1/8” Allen Screws.

Image Removed
Image Added

  • Reattach connectors and airlines by attaching matching connectors together.

Image Removed
Image Added

  • Reattach Head cover using 3mm Allen Screws.

Image Removed
Image Added

  • Attach both top and bottom of the Head cover. Insert Blade into Head.

Image Removed
Image Added