Page Comparison

Note: Not all cartridges are available for all CMC models.

Select Current Bevel Type-Front of Mat when cutting from the front of the mat.

*The different Opening Bevel Types, including whether it is cutting from the Front or Back, controls the cut direction of the Head, and determines whether the cut is a Backup or an Overcut.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• Exterior Backup cuts Too Long.

• Exterior Backup cuts Too Long:

  • Decrease the Exterior Backup.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut too Short, Increase the Exterior Backup.

• Exterior Backup cuts Too Short.

• Exterior Backup cuts Too Short:

  • Increase the Exterior Backup.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut Too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut Too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut Too Short, Increase the Exterior Backup.