Rotation on Creases
| Expand | ||
|---|---|---|
| ||
Select desired Cartridge Tab. Select the desired Bevel Type from Current Bevel Type. Edit the desired Configuration field. |
| Expand | ||
|---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |
Crease has a Swoop
If the Crease has a Swoop, Increase the Rotation.
| Expand | ||
|---|---|---|
| ||
A Swoop in a Crease is where the corners Curve Inward toward the crease. If the Crease has a Swoop, Increase the Rotation. The Rotation controls for Swoops and Flares in Openings. |
| Expand | ||
|---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |
Crease has a Flare
If the Crease has a Flare, Decrease the Rotation.
| Expand | ||
|---|---|---|
| ||
A Flare in a Crease is where the corners Curve Away from the crease. If the Crease has a Flare, Decrease the Rotation. The Rotation controls for Swoops and Flares in Openings. |
| Expand | ||
|---|---|---|
| ||
When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times. Click OK and do another test cut. Continue making adjustments until the desired outcome is achieved. |
Troubleshooting Utility for Openings
If the Crease has a Swoop, Increase the Rotation.
If the Crease has a Flare, Decrease the Rotation.
Use the Troubleshooting Configurations to fine-tune for Swoops/Flares in a Crease.
Contents:
| |