Page Comparison

Note: Not all cartridges are available for all CMC models.

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

Select the desired Cartridge Type Tab. 

Select the desired bevel type from the Current Bevel Type dropdown control.

Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.

Edit the Oval Rotation field.

Adjusting the Oval Rotation

• When adjusting Configurations, click the Plus/Minus on the desired field about five times.

• Click OK and do another test cut.

• Continue making adjustments until the desired outcome is achieved.

• Oval Opening has a Feather.

• Oval Opening has a Feather:

  • Decrease the Oval Rotation.

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

• Oval Opening has a Bump.

• Oval Opening has a Feather/Bump.

• Use the Troubleshooting Configurations to fine-tune for Bumps/Feathers in an Oval Opening.

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

• Oval has a Feather/Bump.

• Use the Circle/Oval Rotation Utility to fine-tune specific sizes of circles/ovals for Feathers and Bumps.

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.