Page Comparison

Select Current Bevel Type-Front of Mat when cutting from the front of the mat.

*The different Opening Bevel Types, including whether it is cutting from the Front or Back, controls the cut direction of the Head, and determines whether the cut is a Backup or an Overcut.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• The Inside of the V-Groove cuts First in a Clockwise direction.

• These are Internal cuts, which cut into the V-Groove Fallout.

• The Outside of the V-Groove cuts Second in a Counter-Clockwise direction.

• These are External cuts, which cut into the Matboard.

• Interior Overcut of the V-Groove cuts Too Long.

• Decrease the Interior Overcut on V-Grooves. 

The V-Groove Interior Overcut controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of the Inside Cut of the V-Groove.

The V-Groove Interior Overcut field is marked with a White Arrow on the Configurations screen and the Map illustration.

If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Long, Decrease the Interior Overcut on V-Grooves.

If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Short, Increase the Interior Overcut on V-Grooves.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• Interior Overcut of the V-Groove cuts Too Short.

• Increase the Interior Overcut on V-Grooves.

The V-Groove Interior Overcut controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of the Inside Cut of the V-Groove.

The V-Groove Interior Overcut field is marked with a White Arrow on the Configurations screen and the Map illustration.

If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Long, Decrease the Interior Overcut on V-Grooves.

If the Interior Overcut on the Inside Cut of the V-Groove is cut Too Short, Increase the Interior Overcut on V-Grooves.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.