Page Comparison

Note: Not all cartridges are available for all CMC models.

The Rotation controls for Swoops and Flares in Non-Oval Objects.

• A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

• This is especially visible from the back of the mat.

1. Check to make sure the Rotation hasn't been set to a high number. 

2. Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

3. Check the Air Regulator for excess water.

4. Use the Clean the Foot Block procedure for cleaning the foot block. 

Select the desired Cartridge Type Tab. 

Select the desired bevel type from the Current Bevel Type dropdown control.

Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.

Edit the Rotation field.

Adjusting the Rotation

• When adjusting Configurations, click the Plus/Minus on the desired field about five times.

• Click OK and do another test cut.

• Continue making adjustments until the desired outcome is achieved.

• Non-Oval Outside has a Swoop.

• Non-Oval Outside has a Swoop:

  • Increase the Rotation.

• Non-Oval Outside has a Flare.

• Non-Oval Outside has a Flare, Decrease the Rotation.