Content Comparison

Note: Not all cartridges are available for all CMC models.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut Too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut Too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut Too Short, Increase the Exterior Backup.

Select Crease Cartridge Tab. 

Select the Crease from Current Bevel Type.

Adjusting the Exterior Backup

• When adjusting Configurations, click the Plus/Minus on the desired field about five times.

• Click OK and do another test cut.

• Continue making adjustments until the desired outcome is achieved.

• Exterior Backup is Too Long.

• Exterior Backup is Too Long:

  • Decrease the Exterior Backup.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut Too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut Too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut Too Short, Increase the Exterior Backup.

• Exterior Backup is Too Short.

• Exterior Backup cuts Too Short:

  • Increase the Exterior Backup.

The Exterior Backup controls where the Blade Plunges into the Matboard (not the Fallout) on the Exterior cut. 

The Exterior Backup field is marked with a Green Arrow on the Configuration screen and the Map illustration.

If the Exterior Backup is cut Too Short, it can leave a Hook in the corner.

If the Exterior Backup is cut Too Long, Decrease the Exterior Backup.

If the Exterior Backup is cut Too Short, Increase the Exterior Backup.