Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Oval Rotation Definition
| title | Oval Rotation Definition |
|---|
| title | Feather Definition |
|---|
| Expand | ||
|---|---|---|
| ||
A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended. |
Adjusting the Oval Rotation
| Tip |
|---|
|
Current Bevel Type
Select the desired Cartridge Type Tab.
Select the desired bevel type from the Current Bevel Type dropdown control.
Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
Oval Opening has a Feather
Problem:
The Oval Openings is cut with a feather.
Resolution:
If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.
Oval Opening has a Bump
Problem:
The Oval Openings is cut with a bump.
Resolution:
If the Oval Opening cuts with a Bump, Increase theOval Rotation.See Also: Troubleshooting Utility for Ovals
Problem:
The Circle/Oval Opening cuts with a Feather/Bump.
Resolution:
Use the Troubleshooting Configurations to fine-tune for Bumps/Feathers in an Oval Opening.
See Also: Circle/Oval Rotation Utility
Problem:
The Circle/Oval cuts with a Feather/Bump.
Resolution:
Use the Circle/Oval Rotation Utility to fine-tune specific sizes of circles/ovals for Feathers and Bumps.
Oval Rotation on Openings | ||||||||||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Contents:
|   | |||||||||||||||||||||||||||||||||||||||||||||||||||