Versions Compared

Old Version 39

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version Current

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Changing the 45 Degree Blade: CMC Z1, Z(9000z), 9000, 8500eSBT, 8500e, 8500, 8000, 8000RC and 8000+

Info

  • The black 45° Blade Cartridge is labeled “45” with a 45° Angle Symbol on the end.

Image RemovedEnd45Cartridge70800.pngImage Added
Info

  • Your hardware may look different than the model pictured, but the process is still the same.

  • Push the Blade Cartridge release lever down to eject the Blade Cartridge.

  • Remove the Blade from Blade Cartridge.Mind , being mindful of the sharp edge.

  • The Blade Cartridge displays a diagram of the Blade orientation (shown in contrast). 

  • Place new Blade into Cartridge with the longest side to the right and the bevel face down, lining up the bottom hole of the Blade over the pin in the Cartridge.

  • The Blade should fit snugly into the recess space provided for it.

Info

  • NOTE: If there is any side-to-side movement of the Blade in the Blade Cartridge, it is time to replace the Blade Cartridge.

  • Insert the Blade Cartridge into the Head with the Blade facing toward the Board and the notch on the back of the Cartridge facing the Head.

  • It should click into place.

    • It can only be inserted one way.