...
Cartridges Involved
This Configuration element involves the following Cartridges.
| Info |
|---|
Note: Not all cartridges are available for all CMC models. |
Rotation on Outsides Definition
| Expand | ||
|---|---|---|
| ||
The Rotation controls for Swoops and Flares in non-oval objects. If the Non-Oval Outside cuts with a Swoop, Increase the Rotation. If the Non-Oval Outside cuts with a Flare, Decrease the Rotation. |
| Expand | ||
|---|---|---|
| ||
A Swoop in a Non-Oval Outside is where the corners curve inward toward the opening. If the Non-Oval Outside cuts with a Swoop, Increase the Rotation. |
| title | Flare Definition |
|---|
Problem:
A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.
This is especially visible from the back of the mat.
Resolution:
Check to make sure the Rotation hasn't been set to a high number.
Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.
Check the Air Regulator for excess water.
Use the Clean the Foot Block procedure for cleaning the foot block.
Rotation on the Outsides | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Contents:
| ||||||||||||||
Adjusting the Rotation
| Tip |
|---|
|
Current Bevel Type
Select the desired Cartridge Type Tab.
Select the desired bevel type from the Current Bevel Type dropdown control.
Select Current Bevel Type-Front of Mat if it is being cut from the front of the mat.
Outside has a Swoop
Problem:
Resolution:
If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.
Outside has a Flare
Problem:
A Flare in a Non-Oval Outside is where the corners curve away from the opening.
Resolution:
If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.
Twisted Corner
|   |